Mazda 626
1991-1998 of release
Repair and operation of the car
Mazda 626
+
1. Maintenance instruction
+
2. Maintenance
-
3. Engines
-
3.1. Petrol engines (1,6 and 1,8 liters)
3.1.1. Introduction
3.1.2. Technical characteristics
3.1.3. Recommendations about repair
3.1.4. Top dead point
3.1.5. Cover of valves
3.1.6. Inlet collector
3.1.7. Final collector
3.1.8. Gas-distributing belt and asterisks
3.1.9. Camshaft epiploons
3.1.10. Yokes and distributive shaft
3.1.11. Springs of valves, fastenings and laying
3.1.12. Head of cylinders
3.1.13. Oil pallet
3.1.14. Forward cover
3.1.15. Oil pump
3.1.16. Forward epiploon of a bent shaft
3.1.17. Flywheel
3.1.18. Back epiploon of a bent shaft
3.1.19. Fastenings of the engine
+
3.2. Petrol 4-cylinder engine (2 liters)
+
3.3. Petrol V6 engine (2,5 liters)
+
3.4. Partition of engines (1,6 and 1,8 liters)
+
3.5. Partition of engines (2,0 and 2,5 liters of V6)
+
3.6. Diesel engine 2,0 liters
+
3.7. Systems of electric equipment of the engine
+
4. Heating and ventilation
+
5. Fuel system
+
6. Exhaust system
+
7. Transmissions
+
8. Coupling and half shafts
+
9. Brake system
+
10. Running gear
+
11. Body
+
12. Electric equipment
+
13. Electrical circuitries
+
14. Useful tips
3.1.9. Camshaft epiploons
Replacement
PERFORMANCE ORDER
1.
Disconnect a wire of the minus plug of the accumulator.
2.
Put the car on the emergency brake.
3.
Install the N1 piston in VMT.
4.
Unscrew a camshaft asterisk bolt, remove an asterisk.
5.
Take an epiploon by means of the small screw-driver.
Installation
PERFORMANCE ORDER
1.
Oil a new epiploon engine and establish into place.
2.
Establish the remained details and check operation of the engine.
home
