Mazda 626

1991-1998 of release

Repair and operation of the car



Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   - 3.1. Petrol engines (1,6 and 1,8 liters)
      3.1.1. Introduction
      3.1.2. Technical characteristics
      3.1.3. Recommendations about repair
      3.1.4. Top dead point
      3.1.5. Cover of valves
      3.1.6. Inlet collector
      3.1.7. Final collector
      3.1.8. Gas-distributing belt and asterisks
      3.1.9. Camshaft epiploons
      3.1.10. Yokes and distributive shaft
      3.1.11. Springs of valves, fastenings and laying
      3.1.12. Head of cylinders
      3.1.13. Oil pallet
      3.1.14. Forward cover
      3.1.15. Oil pump
      3.1.16. Forward epiploon of a bent shaft
      3.1.17. Flywheel
      3.1.18. Back epiploon of a bent shaft
      3.1.19. Fastenings of the engine
   + 3.2. Petrol 4-cylinder engine (2 liters)
   + 3.3. Petrol V6 engine (2,5 liters)
   + 3.4. Partition of engines (1,6 and 1,8 liters)
   + 3.5. Partition of engines (2,0 and 2,5 liters of V6)
   + 3.6. Diesel engine 2,0 liters
   + 3.7. Systems of electric equipment of the engine
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips


4295d568



3.1.6. Inlet collector

Removal

PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator.
2. Merge cooling liquid.
3. Remove an airintaking hose of an inlet collector.
4. Remove the resonator.
5. Disconnect a rope of an accelerator and a rope of a throttle from an inlet collector.
6. Disconnect a plait of wires, hoses and ropes from an inlet collector.
7. Remove an air inlet and a casing of a throttle.
8. Remove the fuel highway.
9. Disconnect hoses and wires from the fuel valve and remove the valve.
10. Lift and fix a forward part of the car. Remove an arm of an inlet collector.
11. Unscrew collector bolts.

12. Lower the car.

13. Remove a collector.

Installation

PERFORMANCE ORDER
1. Carefully clean the joined surfaces of a collector and a head of cylinders. If laying of a collector escaped, address experts.
2. Establish new laying, establish a collector and insert bolts.
3. Tighten bolts in three steps.
4. Establish the remained details and fill in cooling liquid.
5. Check operation of the engine.