|
1. Establish gear rings in a casing of the pump and measure a gap between the leading gear ring and a casing of the pump. |
|
2. Measure a gap between the leader and conducted by gear rings. |
|
3. Measure a gap between the plane of gear rings and the plane of a casing of the pump. |
| 4. Measure length of a spring of the reducing valve, if necessary replace a spring. |
| 5. Oil a new epiploon and establish into place. |
| 6. Oil the piston of the reducing valve engine and install the valve in a pump casing. |
| 7. Grease gear rings and establish in a casing. |
| 8. Establish a cover of the pump and tighten bolts. |
