Mazda 626

1991-1998 of release

Repair and operation of the car

Mazda 626

+ 1. Maintenance instruction
- 2. Maintenance
   2.1. Technical characteristics
   2.2. Schedule of maintenance of Ford Probe, Mazdas 626 and MX-6
   2.3. Primary and secondary checks
   2.4. Check of level of oil and liquids
   2.5. Check of a condition of tires and pressure in tires
   2.6. Check of level of liquid of system of hydrostrengthening of steering
   2.7. Check of level of automatic transmission liquid
   2.8. Replacement of engine oil and oil filter
   2.9. Check of seat belts
   2.10. Survey and replacement of brushes of screen wipers
   2.11. Check, maintenance and accumulator charging
   2.12. Check, adjustment of a tension and replacement of a driving belt
   2.13. Check and replacement of hoses in a motive compartment
   2.14. Check of the cooling system
   2.15. Shift of wheels
   2.16. Check of the brake system
   2.17. Check of level of oil of the mechanical transmission
   2.18. Replacement of the air filter
   2.19. Check and replacement of spark plugs
   2.20. Check and replacement of elements of system of ignition
   2.21. Check and replacement of the valve of ventilation of a case
   2.22. Check and adjustment of speed of idling (model till 1997)
   2.23. Check and adjustment of a corner of an advancing of ignition (model till 1997)
   2.24. Replacement of cooling liquid and washing of the cooling system
   2.25. Replacement of brake fluid
   2.26. Check of steering and suspension bracket
   2.27. Automatic transmission liquid replacement
   2.28. Replacement of oil of the mechanical transmission
   2.29. Check of the exhaust system
   2.30. Check of a power supply system
   2.31. Check and adjustment of gaps of valves (model of 1998 of release)
   2.32. Replacement of the fuel filter
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips


2.8. Replacement of engine oil and oil filter


Tools necessary for replacement of an oil filter

1. Pallet

2. Rubber gloves

3. Handle

4. Nozzle

5. A special key for untwisting of the filter

6. A key for untwisting of the filter

1. Before work prepare necessary tools and materials.
2. Warm up the engine. Remove a cap of a jellied mouth of oil.
3. Lift the car and install it on support.
4. Install the pallet under a drain opening of oil and turn off a cap by means of a cap wrench. Wait until oil flows down. Wipe a cap and establish it into place.
5. Install the pallet under an oil filter and unscrew the filter, rotating it counterclockwise. For untwisting of an oil filter use a special key.
6. Wipe the block of cylinders and an opening for installation of the filter.
7. Oil rubber laying of the new filter engine and twirl the filter into place. Twist the filter a hand until laying of the filter concerns the block of cylinders. Then turn the filter in addition on 3/4 turns.
8. Fill in new engine oil through a jellied mouth. Wait until oil flows down in the pallet. Start the engine and check whether there is no leak. Check the level of oil and add it if it is necessary.

On the homepage