Mazda 626

1991-1998 of release

Repair and operation of the car

Mazda 626

+ 1. Maintenance instruction
- 2. Maintenance
   2.1. Technical characteristics
   2.2. Schedule of maintenance of Ford Probe, Mazdas 626 and MX-6
   2.3. Primary and secondary checks
   2.4. Check of level of oil and liquids
   2.5. Check of a condition of tires and pressure in tires
   2.6. Check of level of liquid of system of hydrostrengthening of steering
   2.7. Check of level of automatic transmission liquid
   2.8. Replacement of engine oil and oil filter
   2.9. Check of seat belts
   2.10. Survey and replacement of brushes of screen wipers
   2.11. Check, maintenance and accumulator charging
   2.12. Check, adjustment of a tension and replacement of a driving belt
   2.13. Check and replacement of hoses in a motive compartment
   2.14. Check of the cooling system
   2.15. Shift of wheels
   2.16. Check of the brake system
   2.17. Check of level of oil of the mechanical transmission
   2.18. Replacement of the air filter
   2.19. Check and replacement of spark plugs
   2.20. Check and replacement of elements of system of ignition
   2.21. Check and replacement of the valve of ventilation of a case
   2.22. Check and adjustment of speed of idling (model till 1997)
   2.23. Check and adjustment of a corner of an advancing of ignition (model till 1997)
   2.24. Replacement of cooling liquid and washing of the cooling system
   2.25. Replacement of brake fluid
   2.26. Check of steering and suspension bracket
   2.27. Automatic transmission liquid replacement
   2.28. Replacement of oil of the mechanical transmission
   2.29. Check of the exhaust system
   2.30. Check of a power supply system
   2.31. Check and adjustment of gaps of valves (model of 1998 of release)
   2.32. Replacement of the fuel filter
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips

2.23. Check and adjustment of a corner of an advancing of ignition (model till 1997)

GENERAL INFORMATION

Tools necessary for check and adjustment of a corner of an advancing of ignition

1. Caps

2. Stroboscope

3. A key for untwisting of a fixing bolt of the distributor of ignition

PERFORMANCE ORDER

1. Warm up the engine up to the normal working temperature.
2. Prepare the tools necessary for check of a corner of an advancing of ignition.
3. Connect a stroboscope.
4. On the Ford Probe models remove a crossing point from the socket of connection SPOUT located between the accumulator and the diagnostic socket of connection. Connect the TEN and GND plugs of the diagnostic socket of connection.
5. Start the engine and direct a stroboscope beam to an adjusting line and a yellow mark in a pulley of a bent shaft. If the yellow mark does not coincide with the necessary mark in an adjusting ruler, turn off a fixing bolt of the distributor of ignition and turn the distributor as it is necessary.
6. Tighten a fixing bolt and again check an ignition advancing corner.

home