| 1. Before installation it is necessary to check trailer and side gaps of piston rings. |
|
2. Install the top compression ring in the cylinder by means of the piston. |
|
3. Measure a trailer gap of a ring. If a gap too small, you can replace piston rings or increase a gap, having ground the ends of a piston ring a small file. |
| 4. Carry out the similar procedure with all rings. |
| 5. After check and adjustment of a trailer gap, a ring it is possible to install on pistons. |
|
|
| 6. The oil scraper ring is established by the first. At first establish a broad ring in a flute, then establish the lower and top oil scraper rings. |
| 7. After installation of all elements of an oil scraper ring check that the top and lower rings rotated freely. |
|
8. Establish the second compression ring by means of the special tool by a mark up. |
| 9. Then establish the top compression ring. |
| 10. Do similar procedures with the remained pistons. |
