| 1. In 4-cylinder engines remove the strengthening engine section (cm. subsection 3.2.14). |
|
2. By means of the special tool remove the ledge in the top part of the cylinder formed as a result of wear and deposits of products of combustion. Do not try to get the piston, without having removed a ledge, otherwise you damage the piston. |
| 3. Turn the engine, a bent shaft up. |
|
4. By means of probes measure a side gap of rods. If the gap exceeds admissible limits, the rod needs to be replaced. At emergence, any doubts, address experts. |
|
5. If rods and covers of rods are not numbered, number them. |
| 6. Weaken nuts of everyone of covers of a rod in stages on a turn floor. Twist nuts, and uncover the first rod and a bearing insert. |
| 7. Remove an insert of the bearing and get a rod together with the piston. |
| 8. Remove other rods and pistons similarly. |
| 9. Put elements of each of pistons separately not to mix them. |
