Mazda 626

1991-1998 of release

Repair and operation of the car



Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines (1,6 and 1,8 liters)
   + 3.2. Petrol 4-cylinder engine (2 liters)
   + 3.3. Petrol V6 engine (2,5 liters)
   + 3.4. Partition of engines (1,6 and 1,8 liters)
   - 3.5. Partition of engines (2,0 and 2,5 liters of V6)
      3.5.1. Introduction
      + 3.5.2. Technical characteristics
      3.5.3. Repair work without dismantle of the engine from the car
      + 3.5.4. Capital repairs of the engine
      3.5.5. Check by means of the vacuum measuring instrument
      3.5.6. Check of a compression
      3.5.7. Methods of dismantle of the engine
      3.5.8. Removal and installation of the engine
      3.5.9. Engine partition
      3.5.10. Partition and check of a head of cylinders
      3.5.11. Valves
      3.5.12. Assembly of a head of cylinders
      3.5.13. Removal of pistons and rods
      3.5.14. Removal of a bent shaft
      3.5.15. Check of the block of cylinders
      3.5.16. Honingovaniye of cylinders
      3.5.17. Check of pistons and rods
      3.5.18. Check of a bent shaft
      3.5.19. Check and selection of radical bearings and bearings of rods
      3.5.20. Check of camshafts and pushers
      3.5.21. Engine assembly order
      3.5.22. Installation of piston rings
      3.5.23. Installation of a bent shaft
      3.5.24. Installation of a back epiploon of a bent shaft
      3.5.25. Installation of pistons and rods
   + 3.6. Diesel engine 2,0 liters
   + 3.7. Systems of electric equipment of the engine
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips


4295d568



3.5.19. Check and selection of radical bearings and bearings of rods

GENERAL INFORMATION

Causes of wear of bearings

1. Decrease in strength of metal; fragmentary scratches
2. It is incorrectly put; the bright (polished) strips
3. It is scratched гразью; dirt ate in the surface of the bearing
4. Lack of oil; the top layer was wiped
5. Excessive wear; the top layer was wiped on all surface
6. The bearing is deformed; the top layer was wiped around

In spite of the fact that at an engine partition old inserts of bearings are replaced with new, it is necessary to examine old inserts carefully. Survey of an insert can establish the reason of its wear.

Damage of bearings happens because of a lack of lubricant, availability of dirt and other foreign debris, an overload of the engine and corrosion. Anyway, the cause of damage of bearings needs to be removed prior to assembly of the engine.

For the correct selection of inserts be guided by the size of a lubricant gap which can be measured by means of a plastic measuring tape. At emergence of any problems with selection of inserts address experts.


On the homepage