Mazda 626

1991-1998 of release

Repair and operation of the car



Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines (1,6 and 1,8 liters)
   + 3.2. Petrol 4-cylinder engine (2 liters)
   + 3.3. Petrol V6 engine (2,5 liters)
   + 3.4. Partition of engines (1,6 and 1,8 liters)
   - 3.5. Partition of engines (2,0 and 2,5 liters of V6)
      3.5.1. Introduction
      + 3.5.2. Technical characteristics
      3.5.3. Repair work without dismantle of the engine from the car
      + 3.5.4. Capital repairs of the engine
      3.5.5. Check by means of the vacuum measuring instrument
      3.5.6. Check of a compression
      3.5.7. Methods of dismantle of the engine
      3.5.8. Removal and installation of the engine
      3.5.9. Engine partition
      3.5.10. Partition and check of a head of cylinders
      3.5.11. Valves
      3.5.12. Assembly of a head of cylinders
      3.5.13. Removal of pistons and rods
      3.5.14. Removal of a bent shaft
      3.5.15. Check of the block of cylinders
      3.5.16. Honingovaniye of cylinders
      3.5.17. Check of pistons and rods
      3.5.18. Check of a bent shaft
      3.5.19. Check and selection of radical bearings and bearings of rods
      3.5.20. Check of camshafts and pushers
      3.5.21. Engine assembly order
      3.5.22. Installation of piston rings
      3.5.23. Installation of a bent shaft
      3.5.24. Installation of a back epiploon of a bent shaft
      3.5.25. Installation of pistons and rods
   + 3.6. Diesel engine 2,0 liters
   + 3.7. Systems of electric equipment of the engine
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips


4295d568



3.5.18. Check of a bent shaft

PERFORMANCE ORDER
1. Clear a bent shaft solvent and dry up it compressed air.
2. Examine bearings of a bent shaft on existence of wear tracks, scratches, corrosion or cracks.
3. Remove jags around lubricant openings and clean openings solvent.
4. Examine a bent shaft on existence of cracks or other damages.
5. Measure diameters of radical and conrod bearings. To reveal conicity and ovality, measure diameter of each of bearings in several points. If necessary the bent shaft needs to be processed in a specialized workshop.
6. Check necks of epiploons of a bent shaft for existence of wear tracks or damages. If epiploons wiped flutes on necks, then new epiploons will pass oil.
7. Measure length of a carving of each of bolts of covers of radical bearings. In four-cylinder engines of a carving of bolts 67,5 mm have to be not longer, and in six-cylinder engines 136 mm are not longer (for long bolts) and 119 mm (for short bolts), otherwise bolts it is necessary to replace.

On the homepage