Mazda 626
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
+ 3.1. Petrol engines (1,6 and 1,8 liters)
- 3.2. Petrol 4-cylinder engine (2 liters)
3.2.1. Introduction
3.2.2. Technical characteristics
3.2.3. Recommendations about repair
3.2.4. Top dead point
3.2.5. Cover of a head of cylinders
3.2.6. Springs, clamps and epiploons of valves
3.2.7. Gas-distributing belt and asterisks
3.2.8. Camshafts and pushers
3.2.9. Inlet collector
3.2.10. Final collector
3.2.11. Head of cylinders
3.2.12. Forward epiploon of a bent shaft
3.2.13. Oil pallet
3.2.14. Oil pump
3.2.15. Flywheel or drive plate
3.2.16. Back epiploon of a bent shaft
3.2.17. Fastenings of the engine
+ 3.3. Petrol V6 engine (2,5 liters)
+ 3.4. Partition of engines (1,6 and 1,8 liters)
+ 3.5. Partition of engines (2,0 and 2,5 liters of V6)
+ 3.6. Diesel engine 2,0 liters
+ 3.7. Systems of electric equipment of the engine
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips
|
Removal
| PERFORMANCE ORDER |
| 1. Lift and fix a forward part of the car. Remove the transmission. |
| 2. If the mechanical transmission is installed in the car, uncover couplings and a clutch plate. |
|
3. Note the correct adjusting provision of a flywheel. Unscrew flywheel bolts, previously having stopped it by means of the screw-driver. |
Prevention
 If you removed a flywheel, try not to turn a bent shaft.
|
| 4. Remove a flywheel. |
| 5. Clean a flywheel surface, and examine it on existence of cracks, severe scratches and other damages. If necessary address the expert. |
|
Installation
Installation is carried out as it should be, the return to removal. |
|
