| 1. Disconnect a wire of the minus plug of the accumulator. |
| 2. Remove the lower guard of the engine. |
| 3. Stop a bent shaft and unscrew a pulley bolt. |
|
4. Remove a pulley of a bent shaft. |
| 5. Take off a gas-distributing belt and an asterisk of a bent shaft. |
| 6. Remove the sensor of a bent shaft. |
|
7. Remember depth of landing of an epiploon and take it by means of the special tool or by means of the screw-driver. |
| 8. Clean a groove of an epiploon and oil a new epiploon engine. |
|
9. Establish an epiploon into place. |
| 10. Establish the remained details, start the engine and check it for existence of leaks. |
