Mazda 626

1991-1998 of release

Repair and operation of the car

Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines (1,6 and 1,8 liters)
   - 3.2. Petrol 4-cylinder engine (2 liters)
      3.2.1. Introduction
      3.2.2. Technical characteristics
      3.2.3. Recommendations about repair
      3.2.4. Top dead point
      3.2.5. Cover of a head of cylinders
      3.2.6. Springs, clamps and epiploons of valves
      3.2.7. Gas-distributing belt and asterisks
      3.2.8. Camshafts and pushers
      3.2.9. Inlet collector
      3.2.10. Final collector
      3.2.11. Head of cylinders
      3.2.12. Forward epiploon of a bent shaft
      3.2.13. Oil pallet
      3.2.14. Oil pump
      3.2.15. Flywheel or drive plate
      3.2.16. Back epiploon of a bent shaft
      3.2.17. Fastenings of the engine
   + 3.3. Petrol V6 engine (2,5 liters)
   + 3.4. Partition of engines (1,6 and 1,8 liters)
   + 3.5. Partition of engines (2,0 and 2,5 liters of V6)
   + 3.6. Diesel engine 2,0 liters
   + 3.7. Systems of electric equipment of the engine
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips

3.2.13. Oil pallet

Removal

PERFORMANCE ORDER

1. Disconnect a wire of the minus plug of the accumulator.
2. Lift and fix a forward part of the car.
3. Remove the lower guard of the engine.
4. Merge engine oil and remove an oil filter.
5. Get the probe for measurement of level of oil.
6. Disconnect a wire from the oxygen sensor. Disconnect an exhaust pipe from a final collector and lower a pipe together with the catalytic converter.
7. Unscrew bolts and remove the oil pallet.

Installation

PERFORMANCE ORDER

1. Carefully clean and wipe with solvent or acetone the joined surfaces of the pallet and the block of cylinders.
2. Clean openings of bolts in the block of cylinders.
3. Examine the oil pallet on existence of cracks and other damages. If you removed a maslozaborny branch pipe, establish a new sealing ring.
4. Apply sealant on a flange of the oil pallet.
5. Install the pallet and tighten bolts.
6. Establish the remained details, start the engine and check the oil pallet for existence of leaks.

home