Mazda 626

1991-1998 of release

Repair and operation of the car


Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Running gear
+ 11. Body
- 12. Electric equipment
   12.1. Introduction
   12.2. Search of a source of malfunction in system of electric equipment
   12.3. Safety locks
   12.4. Automatic switches
   12.5. Relay
   12.6. Breaker of indexes of turns / alarm system
   12.7. Switches on a steering column
   12.8. Switch of ignition and drum of the lock
   12.9. Switches on the dashboard
   12:10. Tools of an instrument guard
   12:11. Instrument guard
   12:12. Radio receiver and loudspeakers
   12:13. Antenna
   12:14. Bulbs of headlights of head light
   12:15. Headlights of head light
   12:16. Drive of headlights of head light
   12:17. Replacement of bulbs
   12:18. Engine of screen wipers
   12:19. Horn of a sound signal
   12:20. System of day inclusion of headlights
   12:21. Heater of back glass
   12:22. System cruise control
   12:23. Power windows
   12:24. Central lock and remote control of the central lock
   12:25. A rear-view mirror with the electric drive
   12:26. Top hatch
   12:27. Safety airbag
+ 13. Electrical circuitries
+ 14. Useful tips


4295d568



12.8. Switch of ignition and drum of the lock
GENERAL INFORMATION

Identification of plugs of the switch of ignition


Table of conductivity of the switch of ignition

The provision of a key in the ignition lock
Conductivity between plugs
Expert
2 and 6
On
2, 4 and 6; 1 and 5
Start
2 and 4; 3 and 5

Check

PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator.
2. Remove casings of a steering column.
3. Disconnect the socket of connection of the switch of ignition.
4. Check existence of conductivity between switch plugs, being guided by the Table of conductivity of the switch of ignition.
5. Check operation of the reel of the lock.

Replacement

PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator. Remove casings of a steering column.
2. Disconnect the connection socket, turn off the fixing screw (it is specified by an arrow) and remove the switch.
Drum of the lock
3. Remove casings of a steering column and the lower panel of finishing.

4. Disconnect a rope (A) from the ignition lock, drill srezny bolts (V) and remove the ignition lock.
5. Drill fixing rivets and remove a drum of the lock.
6. Installation is carried out upside-down removals.