Mazda 626

1991-1998 of release

Repair and operation of the car


Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Running gear
+ 11. Body
- 12. Electric equipment
   12.1. Introduction
   12.2. Search of a source of malfunction in system of electric equipment
   12.3. Safety locks
   12.4. Automatic switches
   12.5. Relay
   12.6. Breaker of indexes of turns / alarm system
   12.7. Switches on a steering column
   12.8. Switch of ignition and drum of the lock
   12.9. Switches on the dashboard
   12:10. Tools of an instrument guard
   12:11. Instrument guard
   12:12. Radio receiver and loudspeakers
   12:13. Antenna
   12:14. Bulbs of headlights of head light
   12:15. Headlights of head light
   12:16. Drive of headlights of head light
   12:17. Replacement of bulbs
   12:18. Engine of screen wipers
   12:19. Horn of a sound signal
   12:20. System of day inclusion of headlights
   12:21. Heater of back glass
   12:22. System cruise control
   12:23. Power windows
   12:24. Central lock and remote control of the central lock
   12:25. A rear-view mirror with the electric drive
   12:26. Top hatch
   12:27. Safety airbag
+ 13. Electrical circuitries
+ 14. Useful tips


4295d568



12:27. Safety airbag
GENERAL INFORMATION

Electronic control unit of system of airbags of safety (it is specified by an arrow).

The system of additional passive safety consists of an electronic control unit, two sensors of collision and modules of airbags of safety.

Principle of work of system

In order that safety cushions were filled with gas, it is necessary that the electronic control unit received signals from one or both sensors of collision and the safety sensor.

System of self-diagnostics

At failure detection the electronic control unit includes an alarm bulb on an instrument guard. In this case it is necessary to address experts immediately.

Maintenance of the elements located near elements of system of the airbag of safety

Sometimes, happens it is necessary to remove a steering wheel, the radio receiver or other element near an instrument guard. It is easy to distinguish wires of system of the airbag of safety as they have bright yellow isolation. Never disconnect sockets of connection and do not use electric instrumentations for check of system of the airbag of safety. Always disconnect system of the airbag of safety before carrying out repair near its elements.

Shutdown of system of the airbag of safety

PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator, then disconnect a wire of the plus plug and wait several minutes.
2. Disconnect the socket of connection of the module of the airbag of safety.

Inclusion of system of the airbag of safety

PERFORMANCE ORDER
1. Connect the socket of connection of the module of the airbag of safety.
2. Connect accumulator wires.

Removal and installation

Module of the airbag of safety of the driver

You watch subsection 10.4.1.

Module of the airbag of safety of the passenger
PERFORMANCE ORDER
1. Disconnect wires of the accumulator and wait several minutes.
2. Remove a glove compartment.
3. Turn off sockets of connection of the module, turn off fixing bolts and remove the safety airbag module.
4. Installation is carried out upside-down removals.