Mazda 626
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Running gear
+ 11. Body
- 12. Electric equipment
12.1. Introduction
12.2. Search of a source of malfunction in system of electric equipment
12.3. Safety locks
12.4. Automatic switches
12.5. Relay
12.6. Breaker of indexes of turns / alarm system
12.7. Switches on a steering column
12.8. Switch of ignition and drum of the lock
12.9. Switches on the dashboard
12:10. Tools of an instrument guard
12:11. Instrument guard
12:12. Radio receiver and loudspeakers
12:13. Antenna
12:14. Bulbs of headlights of head light
12:15. Headlights of head light
12:16. Drive of headlights of head light
12:17. Replacement of bulbs
12:18. Engine of screen wipers
12:19. Horn of a sound signal
12:20. System of day inclusion of headlights
12:21. Heater of back glass
12:22. System cruise control
12:23. Power windows
12:24. Central lock and remote control of the central lock
12:25. A rear-view mirror with the electric drive
12:26. Top hatch
12:27. Safety airbag
+ 13. Electrical circuitries
+ 14. Useful tips
|
|
|
For adjustment of provision of headlights of head light two adjusting screws are provided. |
Scheme of adjustment of headlights of head light
|
|
Adjust headlights of head light, using the provided scheme. At adjustment of passing beam the center of a zone of high illumination has to be about 5 cm lower and crossings of lines are more right. |
Replacement
Mazda models
| PERFORMANCE ORDER |
| 1. Disconnect sockets of connection and remove bulbs. |
| 2. Remove a front grille. |
|
|
3. Remove the index of turns if it is necessary, turn off fixing bolts (are specified by shooters) and remove a headlight. |
| 4. Installation is carried out upside-down removals. |
|
Ford Probe models
| PERFORMANCE ORDER |
| 1. Disconnect a wire of the minus plug of the accumulator. |
|
|
| 2. Turn off fixing bolts (a photo at the left) and nuts (a photo on the right) headlights, disconnect the connection socket. |
| |
3. Disconnect the lever (A) from the mechanism of the elevator (B). Remove a headlight. |
| 4. Installation is carried out upside-down removals. |
|
|
|
