Mazda 626

1991-1998 of release

Repair and operation of the car

Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
- 6. Exhaust system
   + 6.1. Exhaust system
   - 6.2. Systems of decrease in toxicity of exhausts and management of operation of the engine
      6.2.1. Introduction
      6.2.2. System of self-diagnostics and codes of malfunction
      6.2.3. Central control unit
      6.2.4. Sensor of provision of a butterfly valve
      6.2.5. Air stream sensor
      6.2.6. The sensor of temperature of the arriving air
      6.2.7. Sensor of temperature of cooling liquid
      6.2.8. Sensor of provision of a bent shaft
      6.2.9. Sensor of position of the camshaft
      6.2.10. Switch of system of hydrostrengthening of steering
      6.2.11. Oxygen sensor
      6.2.12. Sensor of detonation combustion of fuel
      6.2.13. Speed sensor
      6.2.14. Air valve
      6.2.15. System of additional air supply on low turns
      6.2.16. System of ventilation of a case
      6.2.17. System of recirculation of exhaust gases
      6.2.18. System of collecting vapors of fuel
      6.2.19. Switch of fires of a stoplight
      6.2.20. Catalytic converter
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips

6.2.13. Speed sensor

Check

PERFORMANCE ORDER

	1. Disconnect the socket of connection of the sensor (it is specified by an arrow).
2. Lift the car and install it on support. Connect the voltmeter to the sensor. Block one of forward wheels and rotate the second wheel a hand. The voltmeter has to register the pulsing voltage from 0 to 5 Volts. If is not present, replace the sensor.

Replacement

PERFORMANCE ORDER

1. Disconnect the socket of connection of the sensor, turn off the fixing screw and remove the sensor. Replace a sealing ring.

2. Installation is carried out upside-down removals.

home