Mazda 626

1991-1998 of release

Repair and operation of the car

Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines (1,6 and 1,8 liters)
   + 3.2. Petrol 4-cylinder engine (2 liters)
   + 3.3. Petrol V6 engine (2,5 liters)
   + 3.4. Partition of engines (1,6 and 1,8 liters)
   + 3.5. Partition of engines (2,0 and 2,5 liters of V6)
   + 3.6. Diesel engine 2,0 liters
   - 3.7. Systems of electric equipment of the engine
      3.7.1. Introduction
      3.7.2. Technical characteristics
      3.7.3. Accumulator
      - 3.7.4. System of ignition
         3.7.4.1. Ignition coil
         3.7.4.2. Electronic control unit of system of ignition
         3.7.4.3. Ignition distributor
      3.7.5. System of recharge of the accumulator
      3.7.6. Generator
      + 3.7.7. Starter and system of start of the engine
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips

3.7.4.3. Ignition distributor

Removal

PERFORMANCE ORDER

1. Disconnect a wire of the minus plug of the accumulator.

2. Disconnect wires from the ignition distributor.

3. Uncover the distributor and turn a bent shaft of the engine so that the tip of the runner was turned to the N1 cylinder plug.

4. Make a mark in the distributor case directly under a runner tip.

5. Also mark the provision of installation of the distributor on a head of the block of cylinders.

6. Turn off fixing bolts and remove the distributor.

Installation

PERFORMANCE ORDER

1. Install a new sealing ring on the distributor case.
2. Install the distributor on a head of the block of cylinders in the same situation, as well as before removal. Check that the marks made earlier coincided.
3. Acquire fixing bolts.
4. Further installation is carried out upside-down removals. Check a corner of an advancing of ignition and reliably tighten fixing bolts.

home