Mazda 626

1991-1998 of release

Repair and operation of the car

Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines (1,6 and 1,8 liters)
   + 3.2. Petrol 4-cylinder engine (2 liters)
   + 3.3. Petrol V6 engine (2,5 liters)
   + 3.4. Partition of engines (1,6 and 1,8 liters)
   + 3.5. Partition of engines (2,0 and 2,5 liters of V6)
   + 3.6. Diesel engine 2,0 liters
   - 3.7. Systems of electric equipment of the engine
      3.7.1. Introduction
      3.7.2. Technical characteristics
      3.7.3. Accumulator
      - 3.7.4. System of ignition
         3.7.4.1. Ignition coil
         3.7.4.2. Electronic control unit of system of ignition
         3.7.4.3. Ignition distributor
      3.7.5. System of recharge of the accumulator
      3.7.6. Generator
      + 3.7.7. Starter and system of start of the engine
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips

3.7.4.1. Ignition coil

Check

PERFORMANCE ORDER

Systems of ignition with the ignition distributor

1. Check that ignition was switched off.

2. Disconnect the socket of connection of the coil of ignition and check resistance of primary winding: on models 1993 and 1994 of years of release check resistance between plugs A and C; on models 1995-1997 of years of release check resistance between plugs A and B.

3. Check resistance of a secondary winding of the coil of ignition: on models 1993 and 1994 of years of release check resistance between the plug C and the plug of a wire of high voltage; on models 1995-1997 of years of release check resistance between the plug A and the plug of a wire of high voltage.

4. Replace the ignition coil if it is necessary.

System of ignition without ignition distributor

5. Disconnect the socket of connection of primary windings of the coil. Measure resistance between the minus plug and each of plus plugs.

6. Mark wires of high voltage and disconnect them from the coil. Check resistance between pairs of plugs: on models with the 4-cylinder engine check resistance between the top and lower pairs of plugs; on models with the 6-cylinder engine check a sorotivleniye between pairs of the A-B, C-D and E-F plugs.

7. Replace the coil if it is necessary.

Replacement

PERFORMANCE ORDER

Systems of ignition with the ignition distributor

1. Disconnect a wire of the minus plug of the accumulator.

2. If the coil of ignition is integrated into the ignition distributor, it is necessary to replace the distributor.

3. For replacement of the external coil of ignition, disconnect connection sockets from the coil, turn off fixing nuts and remove the coil.

4. Installation is carried out upside-down removals.

System of ignition without ignition distributor

5. Mark and disconnect wires of high voltage.

6. Turn off fixing bolts (are specified by shooters) and remove the coil.

7. Installation is carried out upside-down removals.

home