Mazda 626

1991-1998 of release

Repair and operation of the car

Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines (1,6 and 1,8 liters)
   + 3.2. Petrol 4-cylinder engine (2 liters)
   + 3.3. Petrol V6 engine (2,5 liters)
   + 3.4. Partition of engines (1,6 and 1,8 liters)
   + 3.5. Partition of engines (2,0 and 2,5 liters of V6)
   + 3.6. Diesel engine 2,0 liters
   - 3.7. Systems of electric equipment of the engine
      3.7.1. Introduction
      3.7.2. Technical characteristics
      3.7.3. Accumulator
      + 3.7.4. System of ignition
      3.7.5. System of recharge of the accumulator
      3.7.6. Generator
      + 3.7.7. Starter and system of start of the engine
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips

3.7.6. Generator

Removal

PERFORMANCE ORDER

1. Disconnect a wire of the minus plug of the accumulator.

2. Disconnect the socket of connection and a wire of "weight" from the generator.

Models with the four-cylinder engine

3. Remove a forward cross-piece and forward section of the exhaust system if it is necessary.

Models with the six-cylinder engine

4. Remove an airintaking branch pipe and a protective guard from below of the engine. Remove the conditioner compressor.

All models

5. On models with the 4-cylinder engine turn off the lock bolt and an adjusting bolt located from above the generator (are specified by shooters). Take off a driving belt from a pulley.

6. Turn off the lower hinged bolt (it is specified by an arrow).

7. On models with the 6-cylinder engine turn off a nut of a natyazhitel and an adjusting bolt (are specified by shooters). Take off a driving belt from a pulley.

8. Turn off the top fixing bolt (it is specified by an arrow).

9. Remove the generator.

Installation

Installation is carried out upside-down removals.

home