Mazda 626

1991-1998 of release

Repair and operation of the car

Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines (1,6 and 1,8 liters)
   + 3.2. Petrol 4-cylinder engine (2 liters)
   - 3.3. Petrol V6 engine (2,5 liters)
      3.3.1. Introduction
      3.3.2. Technical characteristics
      3.3.3. Recommendations about repair
      3.3.4. Top dead point of the first piston
      3.3.5. Covers of heads of cylinders
      3.3.6. Springs, clamps and epiploons of valves
      3.3.7. Gas-distributing belt and asterisks
      3.3.8. Camshafts and pushers
      3.3.9. Inlet collector
      3.3.10. Final collectors
      3.3.11. Heads of cylinders
      3.3.12. Forward epiploon of a bent shaft
      3.3.13. Oil pallet
      3.3.14. Oil pump
      3.3.15. Flywheel or drive plate
      3.3.16. Back epiploon of a bent shaft
      3.3.17. Fastenings of the engine
   + 3.4. Partition of engines (1,6 and 1,8 liters)
   + 3.5. Partition of engines (2,0 and 2,5 liters of V6)
   + 3.6. Diesel engine 2,0 liters
   + 3.7. Systems of electric equipment of the engine
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips

3.3.12. Forward epiploon of a bent shaft

GENERAL INFORMATION

There are two methods of replacement of a forward epiploon of a bent shaft. You can remove the oil pump and beat out an epiploon (the recommended method) or to use easier method described below.

Replacement

PERFORMANCE ORDER

1. Disconnect a wire of the minus plug of the accumulator.
2. Stop a bent shaft and unscrew a pulley bolt.
	3. Remove a pulley of a bent shaft.
4. Take off a gas-distributing belt and an asterisk of a bent shaft.
	5. Remember depth of landing of an epiploon and take it by means of the special tool or by means of the screw-driver.
6. Clean a groove of an epiploon and oil a new epiploon engine.
	7. Establish a new epiploon into place.
8. Establish the remained details, start the engine and check it for existence of leaks.

home