Mazda 626

1991-1998 of release

Repair and operation of the car

Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Running gear
- 11. Body
   11.1. Introduction
   11.2. Maintenance and repair of a body
   11.3. Vinyl finishing
   11.4. Repair of insignificant damages of a body
   11.5. Repair of considerable damages of a body
   11.6. Loops and locks
   11.7. Replacement of a windshield and the neostarted-up glasses
   11.8. Replacement of a front grille (Mazda 626 model)
   11.9. Cowl
   11:10. Bumpers - removal and installation
   11:11. Forward wing
   11:12. The plastic panel before a windshield
   11:13. Panel of finishing of a door
   11:14. Doors
   11:15. Door lock, drum of the lock and handle
   11:16. Door glass
   11:17. Window regulator mechanism
   11:18. Rear-view mirrors
   11:19. Trunk lid (Mazdas 626 and MX-6 models)
   11:20. Lock and drum of the lock of a trunk lid (Mazdas 626 and MX-6 model)
   11:21. Ropes of opening of a cover of the luggage carrier / gate of the fuel tank
   11:22. Back door (Ford Probe models)
   11:23. Lock of a back door and drum of the lock (Ford Probe model)
   11:24. Basic racks of a back door / trunk lid (Ford Probe model, MX-6)
   11:25. Central console
   11:26. Panels of finishing of the dashboard
   11:27. Casing of a steering column
   11:28. Dashboard
   11:29. Sitting
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips

11:26. Panels of finishing of the dashboard

Removal and installation

PERFORMANCE ORDER

1. Disconnect the accumulator.
Panel of finishing of an instrument guard
2. Lower a steering column down.
3. Remove the lower panel of finishing.
	4. On the Ford Probe models turn off five fixing screws (are specified by shooters) and remove the finishing panel.
	5. On the Mazda models turn off the top fixing screws (are specified by shooters).
	6. On the Mazda models turn off the lower fixing screws (are specified by shooters), release fixing latches and remove the finishing panel.
7. Installation is carried out upside-down removals.
Lower panel of finishing
8. Remove forward section of the central console.
9. Remove the handle of opening of a cowl.
	10. Turn off fixing screws (are specified by shooters), release latches and remove the finishing panel.
11. Installation is carried out upside-down removals.
Central panel of finishing
12. Remove the central console.
	13. Turn off the lower fixing screws (are specified by shooters), release latches and remove the finishing panel.
14. Installation is carried out upside-down removals.
Glove compartment
	15. Open a glove compartment, squeeze edges of a glove compartment and lower it down.
	16. Turn off fixing screws (are specified by shooters) and remove a glove compartment.
17. Installation is carried out upside-down removals.

home