Mazda 626

1991-1998 of release

Repair and operation of the car

Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Running gear
- 11. Body
   11.1. Introduction
   11.2. Maintenance and repair of a body
   11.3. Vinyl finishing
   11.4. Repair of insignificant damages of a body
   11.5. Repair of considerable damages of a body
   11.6. Loops and locks
   11.7. Replacement of a windshield and the neostarted-up glasses
   11.8. Replacement of a front grille (Mazda 626 model)
   11.9. Cowl
   11:10. Bumpers - removal and installation
   11:11. Forward wing
   11:12. The plastic panel before a windshield
   11:13. Panel of finishing of a door
   11:14. Doors
   11:15. Door lock, drum of the lock and handle
   11:16. Door glass
   11:17. Window regulator mechanism
   11:18. Rear-view mirrors
   11:19. Trunk lid (Mazdas 626 and MX-6 models)
   11:20. Lock and drum of the lock of a trunk lid (Mazdas 626 and MX-6 model)
   11:21. Ropes of opening of a cover of the luggage carrier / gate of the fuel tank
   11:22. Back door (Ford Probe models)
   11:23. Lock of a back door and drum of the lock (Ford Probe model)
   11:24. Basic racks of a back door / trunk lid (Ford Probe model, MX-6)
   11:25. Central console
   11:26. Panels of finishing of the dashboard
   11:27. Casing of a steering column
   11:28. Dashboard
   11:29. Sitting
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips

11:11. Forward wing

Removal and installation

PERFORMANCE ORDER

1. Lift the car and install it on support.
2. Remove a casing of a front bumper.
	3. Turn off fixing screws (are specified by shooters) and remove an insert of a wheel niche.
	4. Open a cowl and turn off the top fixing bolts of a wing (are specified by shooters).
	5. Turn off the lower fixing bolts (are specified by shooters).
	6. Turn off bolts on the side panel (are specified by shooters); if it is necessary, remove the panel of finishing (A) for access to bolts.
7. Remove a wing.
8. Installation is carried out upside-down removals.

home