Mazda 626

1991-1998 of release

Repair and operation of the car

Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Running gear
- 11. Body
   11.1. Introduction
   11.2. Maintenance and repair of a body
   11.3. Vinyl finishing
   11.4. Repair of insignificant damages of a body
   11.5. Repair of considerable damages of a body
   11.6. Loops and locks
   11.7. Replacement of a windshield and the neostarted-up glasses
   11.8. Replacement of a front grille (Mazda 626 model)
   11.9. Cowl
   11:10. Bumpers - removal and installation
   11:11. Forward wing
   11:12. The plastic panel before a windshield
   11:13. Panel of finishing of a door
   11:14. Doors
   11:15. Door lock, drum of the lock and handle
   11:16. Door glass
   11:17. Window regulator mechanism
   11:18. Rear-view mirrors
   11:19. Trunk lid (Mazdas 626 and MX-6 models)
   11:20. Lock and drum of the lock of a trunk lid (Mazdas 626 and MX-6 model)
   11:21. Ropes of opening of a cover of the luggage carrier / gate of the fuel tank
   11:22. Back door (Ford Probe models)
   11:23. Lock of a back door and drum of the lock (Ford Probe model)
   11:24. Basic racks of a back door / trunk lid (Ford Probe model, MX-6)
   11:25. Central console
   11:26. Panels of finishing of the dashboard
   11:27. Casing of a steering column
   11:28. Dashboard
   11:29. Sitting
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips

11:18. Rear-view mirrors

Removal and installation

PERFORMANCE ORDER

External rear-view mirrors
1. On models with the electric drive of rear-view mirrors remove the panel of finishing of a door.
	2. Remove the side panel.
	4. Disconnect the socket of connection of a mirror(s), turn off fixing screws (are specified by shooters) and remove a mirror.
5. Installation is carried out upside-down removals.
Internal rear-view mirror
Models till 1997 of release:
	6. Turn off the fixing screw and remove a mirror from fastening.
7. Installation is carried out upside-down removals.
Models since 1998 of release:
8. Insert the thin screw-driver into fastening of a mirror and release a fixing clip. Remove a mirror.
9. At installation insert a mirror into fastening and check that the latch recorded a mirror.

home