Mazda 626

1991-1998 of release

Repair and operation of the car



Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Running gear
- 11. Body
   11.1. Introduction
   11.2. Maintenance and repair of a body
   11.3. Vinyl finishing
   11.4. Repair of insignificant damages of a body
   11.5. Repair of considerable damages of a body
   11.6. Loops and locks
   11.7. Replacement of a windshield and the neostarted-up glasses
   11.8. Replacement of a front grille (Mazda 626 model)
   11.9. Cowl
   11:10. Bumpers - removal and installation
   11:11. Forward wing
   11:12. The plastic panel before a windshield
   11:13. Panel of finishing of a door
   11:14. Doors
   11:15. Door lock, drum of the lock and handle
   11:16. Door glass
   11:17. Window regulator mechanism
   11:18. Rear-view mirrors
   11:19. Trunk lid (Mazdas 626 and MX-6 models)
   11:20. Lock and drum of the lock of a trunk lid (Mazdas 626 and MX-6 model)
   11:21. Ropes of opening of a cover of the luggage carrier / gate of the fuel tank
   11:22. Back door (Ford Probe models)
   11:23. Lock of a back door and drum of the lock (Ford Probe model)
   11:24. Basic racks of a back door / trunk lid (Ford Probe model, MX-6)
   11:25. Central console
   11:26. Panels of finishing of the dashboard
   11:27. Casing of a steering column
   11:28. Dashboard
   11:29. Sitting
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips


4295d568



11:10. Bumpers – removal and installation

Front bumper

PERFORMANCE ORDER
1. Lift the car and install it on support.
2. Disconnect the accumulator and wait several minutes.
3. Turn off fixing bolts of the air panel, a radiator and fastening of a bumper (are specified by shooters).
4. Turn off fixing bolts of an airintaking branch pipe (it is specified by an arrow).
5. Turn off fixing screws of an insert of a wheel niche and casing of a bumper (are specified by shooters).
6. Turn off fixing bolts of a casing (are specified by shooters) and remove a bumper casing.
7. Remove a casing, turn off fixing nuts (are specified by shooters) and remove a bumper.
8. Installation is carried out upside-down removals.

Rear bumper

PERFORMANCE ORDER
1. Lift a back part of the car and install it on support.
2. Turn off fixing bolts (are specified by shooters) a bumper on each side.
3. Turn off fixing screws at bottom edge of a casing of a bumper (are specified by shooters).
4. Turn off back block headlights and turn off the top fixing screws of a casing of a bumper (are specified by shooters).
5. Turn off the fixing bolts of a casing located in a luggage carrier (it is specified by an arrow) on each of the parties of a bumper.
6. Turn off fixing nuts (are specified by shooters) and remove a bumper and a casing.
7. Installation is carried out upside-down removals.