Mazda 626

1991-1998 of release

Repair and operation of the car

Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Running gear
- 11. Body
   11.1. Introduction
   11.2. Maintenance and repair of a body
   11.3. Vinyl finishing
   11.4. Repair of insignificant damages of a body
   11.5. Repair of considerable damages of a body
   11.6. Loops and locks
   11.7. Replacement of a windshield and the neostarted-up glasses
   11.8. Replacement of a front grille (Mazda 626 model)
   11.9. Cowl
   11:10. Bumpers - removal and installation
   11:11. Forward wing
   11:12. The plastic panel before a windshield
   11:13. Panel of finishing of a door
   11:14. Doors
   11:15. Door lock, drum of the lock and handle
   11:16. Door glass
   11:17. Window regulator mechanism
   11:18. Rear-view mirrors
   11:19. Trunk lid (Mazdas 626 and MX-6 models)
   11:20. Lock and drum of the lock of a trunk lid (Mazdas 626 and MX-6 model)
   11:21. Ropes of opening of a cover of the luggage carrier / gate of the fuel tank
   11:22. Back door (Ford Probe models)
   11:23. Lock of a back door and drum of the lock (Ford Probe model)
   11:24. Basic racks of a back door / trunk lid (Ford Probe model, MX-6)
   11:25. Central console
   11:26. Panels of finishing of the dashboard
   11:27. Casing of a steering column
   11:28. Dashboard
   11:29. Sitting
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips

11:23. Lock of a back door and drum of the lock (Ford Probe model)

Removal and installation

PERFORMANCE ORDER

Lock
	1. Turn off fixing screws and remove rivets (are specified by shooters), remove panels of finishing of a luggage carrier.
2. Mark the provision of installation of the lock.
	3. Turn off two fixing bolts (are specified by shooters) and disconnect drafts and a rope.
4. Installation is carried out upside-down removals.
Drum of the lock
5. Remove the right block headlight.
	6. Disconnect draft of the lock and turn off fixing bolts (are specified by shooters).
7. Remove a drum of the lock.
8. Installation is carried out upside-down removals.

home