Mazda 626

1991-1998 of release

Repair and operation of the car

Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
- 4. Heating and ventilation
   4.1. Introduction
   4.2. Technical characteristics
   4.3. Thermostat
   4.4. The cooling fans
   4.5. Radiator and broad tank
   4.6. Water pump
   4.7. Sensor of temperature of cooling liquid
   4.8. Oil heater of the engine (6-cylinder models)
   4.9. Electric chain of the motor of the delivery fan
   4.10. Motor of the delivery fan
   4.11. Control unit of a heater and air conditioner
   4.12. Heater radiator
   + 4.13. Systems of air conditioning and heating
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips

Рибальські снасті

4.12. Heater radiator

Replacement

PERFORMANCE ORDER

1. Disconnect a wire of the minus plug of the accumulator.

2. Merge cooling liquid.

3. Remove the central console and the dashboard.

4. Disconnect hoses from the heater block (are specified by shooters).

5. Unscrew bolts and twist nuts of the block of the evaporator and the motor of the delivery fan. Arrange the block aside that it did not prevent removal of a heater.

6. Weaken a nut (A) and twist two top nuts (In).

7. Twist the lower nut (it is specified by an arrow) the heater block.

8. Remove a heater.

9. Unscrew four bolts (are specified by shooters) heater radiator covers.

10. Get a radiator from the heater block.

11. Installation is carried out upside-down removals.

On the homepage