Mazda 626

1991-1998 of release

Repair and operation of the car

Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
- 10. Running gear
   10.1. Introduction
   10.2. Technical characteristics
   - 10.3. Suspension brackets
      - 10.3.1. Rack of a forward suspension bracket
         10.3.1.1. Replacement of elements of a rack of a suspension bracket
         10.3.1.2. Nave arm
         10.3.1.3. Nave and hug bearing of a forward wheel
         10.3.1.4. Stabilizer of cross stability of a forward suspension bracket
         10.3.1.5. Suspension bracket lever
         10.3.1.6. Replacement of spherical hinges
      + 10.3.2. Rack of a back suspension bracket
      10.3.3. Size of tires
      10.3.4. Angles of installation of wheels
   + 10.4. Steering
+ 11. Body
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips

10.3.1.4. Stabilizer of cross stability of a forward suspension bracket

Removal and installation

PERFORMANCE ORDER

1. Remove forward wheels.
2. Remove a cross-piece from below of a motive compartment.
3. Remove a fixing arm of the transmission.
4. Disconnect the socket of connection of the oxygen sensor.
5. Disconnect a reception pipe from a final collector.
6. Disconnect drafts from the transmission.
	7. Disconnect connecting drafts from a bar of the stabilizer of cross stability.
	8. Remove fastenings of a bar of the stabilizer of cross stability.
9. Establish a jack under a cross-piece of a forward suspension bracket, turn off four fixing bolts and two nuts and lower a cross-piece.
10. Remove the stabilizer of cross stability from the car.
11. Check a condition of plugs of fastenings and spherical hinges of connecting drafts. Replace worn-out elements.
12. Installation is carried out upside-down removals.

home