Mazda 626

1991-1998 of release

Repair and operation of the car

Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
- 10. Running gear
   10.1. Introduction
   10.2. Technical characteristics
   - 10.3. Suspension brackets
      + 10.3.1. Rack of a forward suspension bracket
      - 10.3.2. Rack of a back suspension bracket Arm of a nave of a back wheel Nave and hug bearing of a back wheel Stabilizer of cross stability of a back suspension bracket Lever of a back suspension bracket
      10.3.3. Size of tires
      10.3.4. Angles of installation of wheels
   + 10.4. Steering
+ 11. Body
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips


10.3.2. Rack of a back suspension bracket


1. Remove a back wheel.
2. Remove a fixing clip of a brake hose (A) and a wire of the ABS sensor from fastenings on a rack. Turn off fixing nuts (V) and remove bolts of fastening of an arm of a nave to a rack.
3. Remove a nave arm from a rack.
4. Remove the finishing panel in a luggage carrier for receiving access to top
to fastening of a rack.
5. Turn off the top fixing nuts and remove a rack.


Check a condition of a rack of a suspension bracket as it is described in subsection 10.3.1.

Replace a rack or a spring if it is necessary.


Installation is carried out upside-down removals.

On the homepage