Mazda 626

1991-1998 of release

Repair and operation of the car

Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
- 8. Coupling and half shafts
   8.1. Introduction
   8.2. Technical characteristics
   - 8.3. Coupling
      8.3.1. Coupling switching off drive cylinders
      8.3.2. Hydraulic system of the drive of switching off of coupling
      8.3.3. Coupling mechanism elements
      8.3.4. Release bearing and fork of the release bearing
      8.3.5. Adjustment of a pedal of coupling
      8.3.6. Blocking switch
   + 8.4. Half shafts
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips

8.3.6. Blocking switch

GENERAL INFORMATION

Sockets of connection of the blocking switch

1. 3-shtyrkovy socket of connection

2. 5-shtyrkovy socket of connection

Check

PERFORMANCE ORDER

Check that the switch closed a chain when pressing a coupling pedal. At the same time between plugs 1 and 2 of the socket of connection there has to be a conductivity. When the pedal is released, the switch has to disconnect a chain. Adjust or replace the switch if it is necessary.

Replacement

PERFORMANCE ORDER

1. Disconnect the socket of connection of the switch. Further, depending on model, turn the switch on 90 ° and remove it from a fixing arm or turn off two fixing screws and remove the switch.

2. Installation is carried out upside-down removals.

Adjustment

PERFORMANCE ORDER

Turn off fixing nuts and change position of the switch as it is necessary. Tighten fixing nuts.

home