Mazda 626

1991-1998 of release

Repair and operation of the car

Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
- 8. Coupling and half shafts
   8.1. Introduction
   8.2. Technical characteristics
   - 8.3. Coupling
      8.3.1. Coupling switching off drive cylinders
      8.3.2. Hydraulic system of the drive of switching off of coupling
      8.3.3. Coupling mechanism elements
      8.3.4. Release bearing and fork of the release bearing
      8.3.5. Adjustment of a pedal of coupling
      8.3.6. Blocking switch
   + 8.4. Half shafts
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips


8.3.4. Release bearing and fork of the release bearing


1. Remove the working cylinder of the drive of switching off of coupling.
2. Remove the transmission.
3. Remove a bearing fork from a spherical support, press on a spring and remove the release bearing together with a fork.


1. Try to rotate an internal path of the bearing, having pressed on it. Replace the bearing if it is necessary.
2. Examine the release lever on existence of cracks or deformation.


1. Fill an internal flute of the release bearing with high-temperature lubricant. Also grease vents of an entrance shaft, a spherical support and fastening of the bearing.
2. Grease with high-temperature lubricant a nest on the lever and the ends of a fork of the release bearing, install the bearing on a fork.
3. Install the bearing on a shaft and establish a bearing fork on a spherical support.
4. Further installation is carried out upside-down removals.