Mazda 626

1991-1998 of release

Repair and operation of the car

Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
- 5. Fuel system
   + 5.1. Nikki 30/34 carburetor
   + 5.2. Power supply system (l engines 1,6 and 1,8)
   - 5.3. Power supply system (l engines 2,0 and 2,5)
      5.3.1. Introduction
      5.3.2. Technical characteristics
      5.3.3. Dumping of pressure in fuel system
      5.3.4. Fuel pump and fuel pressure
      5.3.5. Fuel tubes and connections of tubes
      5.3.6. Fuel level measuring instrument sensor
      5.3.7. Fuel tank
      5.3.8. Casing of the air filter
      5.3.9. Accelerator rope
      5.3.10. Electronic system of injection of fuel
      5.3.11. Casing of a butterfly valve
      5.3.12. Fuel pressure regulator
      5.3.13. Fuel highway and injectors
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips

5.3.6. Fuel level measuring instrument sensor

Check

PERFORMANCE ORDER

1. Disconnect a wire of the minus plug of the accumulator.

2. Remove the fuel pump and the measuring instrument of level of fuel.

3. Connect an ohmmeter to contacts and measure resistance. Measure the sensor resistance when the lever of the measuring instrument is lowered completely down (the tank is empty) – 105 Ohms and when the lever is completely lifted (the tank is full) – 3–6 Ohms. When moving the lever resistance has to change evenly.

4. If necessary replace the sensor.

Replacement

PERFORMANCE ORDER

1. Disconnect a wire of the minus plug of the accumulator.
2. Remove the fuel pump and the measuring instrument of level of fuel.
	3. Disconnect contacts of the sensor.
	4. Unscrew screws and disconnect the sensor block from an arm of the fuel pump.
5. Installation is carried out upside-down removals.

home