Mazda 626

1991-1998 of release

Repair and operation of the car

Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
- 5. Fuel system
   + 5.1. Nikki 30/34 carburetor
   - 5.2. Power supply system (l engines 1,6 and 1,8)
      5.2.1. Introduction
      5.2.2. Technical characteristics
      5.2.3. Release of pressure from a power supply system
      5.2.4. The fuel pump/pressure in a power supply system
      5.2.5. Fuel tubes and connections
      5.2.6. Removal and installation of the fuel pump
      5.2.7. Fuel level sensor
      5.2.8. Fuel tank
      5.2.9. Air filter
      5.2.10. Accelerator rope
      + 5.2.11. System of electronic injection of fuel
   + 5.3. Power supply system (l engines 2,0 and 2,5)
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips

5.2.8. Fuel tank

GENERAL INFORMATION

Scheme of connections and fastenings of the fuel tank

1. Fuel pump
2. Fuel tank
3. Jellied mouth
4. Control valve
5. Control valve and locking valve
6. Separator

7. Hoses of system of collecting vapors of fuel
8. Fuel hoses
9. Fixing strip
10. Insulator

Cleaning and repair of the fuel tank

Any works on repair of a tank or jellied mouth have to be carried out by the highly skilled personnel having experience in so dangerous and responsible works.

Even after cleaning and washing of fuel system residual explosive couples which can ignite during repair of a tank can accumulate.

If the fuel tank is removed from the car, it should not be stored in those places in which there is a danger of explosion of vapors from a spark or naked flame.

Observe extra care in a garage with a supply of natural gas as antiemergency gas lighting can be a cause of explosion.

Removal and installation

PERFORMANCE ORDER

1. Disconnect hoses and the socket of connection from the fuel pump.
2. Establish a jack under the fuel tank.
	3. Weaken a collar of a hose of a jellied mouth.
	4. Disconnect hoses of system of collecting vapors of fuel from the fuel tank.
	5. Turn off bolts of fixing collars and remove the fuel tank.
6. Installation is carried out upside-down removals.

home