Mazda 626

1991-1998 of release

Repair and operation of the car

Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
- 10. Running gear
   10.1. Introduction
   10.2. Technical characteristics
   + 10.3. Suspension brackets
   - 10.4. Steering
      10.4.1. Steering wheel
      10.4.2. Steering column
      10.4.3. Tips of steering drafts
      10.4.4. Replacement of covers of the steering mechanism
      10.4.5. Steering mechanism
      10.4.6. Pump of system of hydrostrengthening of steering
      10.4.7. Pumping of system of hydrostrengthening of steering
+ 11. Body
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips

10.4.5. Steering mechanism

Removal

PERFORMANCE ORDER

1. Establish forward wheels directly. Remove a wheel and protective guards from below of the engine.
2. Connect the winch to the engine.
3. Disconnect steering drafts from nave arms.
4. Remove a cross-piece and a fixing arm of the transmission. Disconnect the socket of connection of the oxygen sensor. Disconnect a reception pipe from a final collector.
	5. Install the pallet under the steering mechanism and disconnect hydraulic tubes from the steering mechanism (it is specified by an arrow) and the return pipeline from the steering mechanism.
6. Remove a cover of the universal hinge. Mark the provision of installation of the hinge on entrance to a shaft of the steering mechanism. Turn off a coupling bolt of the hinge.
7. Remove back fastening of the engine.
8. Lower a cross-piece of a suspension bracket and remove the stabilizer of cross stability.
	9. Turn off fixing bolts (are specified by shooters), disconnect a shaft of a steering column from the steering mechanism and remove the steering mechanism. Replace inserts of fastenings of the steering mechanism if they are worn-out.

Installation

Installation is carried out upside-down removals.

home